Engineer's calculations for a Charlton Kings project — steel beams sized, padstones and load paths worked out and a signed calculations package your builder and Cheltenham Borough Council's building control can build from, delivered in days and revised free until it is approved.
Cheltenham Borough Council granted 98% of the householder planning decisions it made in its latest published year — 11 points above the 87% England-wide householder average. Charlton Kings contains Cudnall Street, St Mary's conservation areas (Cudnall Street designated 1989), so materials, fenestration and roof form are assessed against the appraisal, which is where a policy-literate drawing pack earns its keep. Its dominant Victorian (1837–1901) and postwar (1945–1970) housing stock sets the design brief on most streets.
Under Class B, a rear dormer stays permitted development up to 40m³ of added roof volume on a terrace or 50m³ on a semi-detached or detached house, while Class A allows a single-storey rear extension of 3m beyond the original rear wall on a terrace and 4m on a detached house before a full application is needed. Charlton Kings carries at least one Article 4 direction, and conservation areas including Cudnall Street and St Mary's remove those rights outright, so we confirm your exact address before a line is drawn. A validated householder application in Charlton Kings is determined against an 8-week statutory target.
Cudnall Street (conservation area designated in 1989) and St Mary's (conservation area designated in 1989) — these are the Charlton Kings pockets our drawings cover most. Heritage designations here include Cudnall Street and St Mary's. Cheltenham Borough Council weighs each proposal against Cheltenham Borough Council's development plan and the design policies it applies to householder applications, where the 2,450 homes here are 22% pre-1900, 21% 1965-1972, 13% 1955-1964, which is what sets the realistic roof and rear-projection options. On roofs the borough is steeply pitched slate roofs, valley gutters and party parapets typical of pre-1900 building and shallow-pitched roofs and integral garages typical of that period's building, over Victorian and earlier houses (22% of 2,450 homes), late-1960s and early-1970s houses (21%) and late-1950s and early-1960s houses (13%).
Charlton Kings's designated heritage is specific, and it is the first thing we check against your address: Cudnall Street (conservation area designated in 1989) and St Mary's (conservation area designated in 1989). Inside those boundaries permitted development is curtailed and Cheltenham Borough Council assesses materials, window detail and roof form against the area's own appraisal, so a scheme that would be waved through two streets away can need a full application here.
Cheltenham Borough Council has 1 recorded Article 4 direction — check the address before assuming PD applies in Charlton Kings.
On stock, Charlton Kings is Victorian and earlier houses (22% of 2,450 homes), late-1960s and early-1970s houses (21%) and late-1950s and early-1960s houses (13%) — which is why steeply pitched slate roofs, valley gutters and party parapets typical of pre-1900 building and shallow-pitched roofs and integral garages typical of that period's building govern what a loft or rear projection can realistically be. Cheltenham Borough Council decided 570 householder applications in the latest published year and granted 98%, with 76% issued inside the eight-week target. Those are the numbers our drawings are prepared against.
The full build-period split for Charlton Kings runs pre-1900 22% (530 homes), 1900-1918 5% (130 homes), 1919-1929 3% (80 homes), 1930-1939 9% (220 homes), 1945-1954 4% (90 homes), 1955-1964 13% (320 homes), 1965-1972 21% (520 homes), 1973-1982 9% (220 homes), 1983-1992 4% (100 homes), 1993-1999 2% (50 homes) and 2000-2008 4% (110 homes). That distribution is why pre-1900 detailing dominates the drawings here, and it is measured from council-tax records rather than assumed from the street name.
Cheltenham Borough Council also decides for Charlton Park and Swindon Village, so a decision in Charlton Kings sits inside a wider pattern of decisions we track across the same authority — useful when an officer cites a precedent from the next area over.
The Article 4 directions recorded for this council include St Pauls Ward. Each removes a specific permitted-development right inside its own boundary, which is why the check is done on the address rather than on the town.
Published figures for Charlton Kings and Cheltenham Borough Council. These are the numbers that decide what is realistic on your street, so we work from them rather than from national averages.
| Measure | Charlton Kings |
|---|---|
| Dwellings recorded | 2,450 |
| Built pre-1900 | 530 (22%) |
| Built 1900-1918 | 130 (5%) |
| Built 1919-1929 | 80 (3%) |
| Built 1930-1939 | 220 (9%) |
| Built 1945-1954 | 90 (4%) |
| Built 1955-1964 | 320 (13%) |
| Built 1965-1972 | 520 (21%) |
| Built 1973-1982 | 220 (9%) |
| Built 1983-1992 | 100 (4%) |
| Built 1993-1999 | 50 (2%) |
| Built 2000-2008 | 110 (4%) |
| Built before 1919 | 27% |
| Built 1919–1939 | 12% |
| Built 1945–2008 | 58% |
| Conservation areas in Charlton Kings | 2 (Cudnall Street, St Mary's) |
| Conservation areas district-wide | 7 |
| Article 4 directions recorded | 1 |
| Householder applications decided | 570 |
| Householder applications granted | 98% |
| Decided within 8 weeks | 76% |
Dwelling stock from VOA council-tax data at 31 March 2025; conservation-area and Article 4 counts from planning.data.gov.uk (MHCLG); decision figures are Cheltenham Borough Council's own, from MHCLG live table PS2 for the year to 31 March 2026.
The moment a wall comes out or a new floor goes in, something has to carry the load that wall or floor was holding — and building control will not accept "it looks strong enough". The engineer traces the load path: the weight of the roof, floors and walls above is gathered into a beam, the beam is sized in steel or timber to carry it within safe deflection, and that load is passed through padstones into the masonry and down to the ground. On Charlton Kings's Victorian and earlier houses (22% of 2,450 homes), late-1960s and early-1970s houses (21%) and late-1950s and early-1960s houses (13%), the spans and loads differ house to house, so every calculation is specific to the property.
The deliverable is two things that work together: the calculations, which show the maths an approved inspector can check, and the structural drawings, which turn that maths into something a builder can order and fit — a beam schedule with sizes and lengths, bearing and padstone details, and connection notes. Charlton Kings contains Cudnall Street, St Mary's conservation areas (Cudnall Street designated 1989), so materials, fenestration and roof form are assessed against the appraisal, and the calculations are drawn to sit alongside the architectural set rather than contradict it. Everything is signed by a chartered or incorporated engineer carrying professional indemnity insurance.
Older Charlton Kings stock — the kind found across Cudnall Street and St Mary's — often hides the real structural question: shallow Victorian foundations, timber that has been notched by past work, or a wall that turns out to be load-bearing when the drawings assumed otherwise. Cheltenham Borough Council has 1 recorded Article 4 direction — check the address before assuming PD applies in Charlton Kings. A survey-based calculation catches this before the wall is opened, not after.
Building control needs an engineer's calculations whenever you change how the building carries load. On a typical Charlton Kings project that means any of these:
We size the steel, work the padstones and bearings, trace the load to the foundations and issue a signed calculations package and a beam schedule for Cheltenham Borough Council's building control — coordinated with your architectural drawings so the beam that is calculated is the beam that is drawn and the beam that is ordered.
Below is Cheltenham Borough Council's real householder decision record, drawn from official planning statistics and refreshed as new data lands. Cheltenham Borough Council granted 98% of its householder applications in the year to 31 March 2026, and Cudnall Street shapes what is approved here. Structural calculations sit behind building control rather than planning, but the same wave of loft, extension and knock-through work that drives these decisions is exactly what needs an engineer's package.
Source: MHCLG planning application statistics (householder decisions, England, 1 April 2025 - 31 March 2026). Compare every borough on our London approval-rate league table.
Tell us about your project and get a fixed, no-obligation quote back within one working day. If you don't need planning permission at all, we'll tell you that too — for free.
Building control approves structural work by checking the numbers, not by looking at the finished steel. Cheltenham Borough Council's inspector, or an approved inspector acting for you, reads the calculations to confirm the beam is deep enough for its span, that deflection stays within limits so ceilings do not crack, that the bearing length and padstones spread the point load into masonry that can take it, and that the load has somewhere to go all the way to the ground. Across Cudnall Street and St Mary's, the recurring issue is a beam sized off a rule of thumb that the actual span will not support.
The 2,450 homes here are 22% pre-1900, 21% 1965-1972, 13% 1955-1964, which is what sets the realistic roof and rear-projection options. We issue calculations detailed enough to be signed off without a query, coordinate them with the architect's drawings so nothing conflicts on site, and stay available to revise if the builder finds the Charlton Kings property is not quite as the survey assumed — free, until the work is approved.
We calculate beams, openings and floors on the period and modern stock across the borough. A few of the Charlton Kings neighbourhoods where structural packages come up most often:
Structural calculations for Cudnall Street's conservation area designated in 1989 — beams sized, load paths traced and signed for Cheltenham Borough Council's building control.
Structural calculations for St Mary's's conservation area designated in 1989 — beams sized, load paths traced and signed for Cheltenham Borough Council's building control.
Different jobs load the building differently, so each needs its own calculation. This is what the common Charlton Kings projects typically require.
| Project | Typical structure | What the calculation proves | Signed off by |
|---|---|---|---|
| Wall knock-through | Steel beam on padstones | Span, deflection and bearing | Building control |
| Loft conversion | New floor beams and ridge/purlin steels | Floor loading and roof support | Building control |
| Rear or side extension | Opening beam plus extension roof and floor | Combined loads and foundations | Building control |
| Basement or underpinning | Retaining and foundation design | Ground and adjacent-building loads | Building control & party wall |
On older Charlton Kings stock around Cudnall Street and St Mary's, shallow foundations and altered structure often mean the calculation drives the design rather than following it.
A fixed process built around building control rather than planning — most calculation packages are ready within five days of the architectural drawings.
Send us your Charlton Kings postcode and the architect's drawings or a sketch. We confirm what structure the project needs, flag any load-bearing wall or foundation question, and tell you exactly what the calculation package will cover.
Where the loads are not obvious — an unknown wall, an old alteration, a deep span — we survey the property so the beam is sized on what is really there, not an assumption.
A chartered or incorporated engineer sizes the steel, works the padstones and load path, and issues the signed calculations and a beam schedule coordinated with your Charlton Kings architectural set.
We submit the calculations to Cheltenham Borough Council's building control or your approved inspector, answer queries, and revise free if the build uncovers something the survey could not see.
Whenever you change how the building carries weight — removing or opening a load-bearing wall, converting a loft, building an extension, or inserting a beam or column. Cheltenham Borough Council's building control needs an engineer's calculation to approve any of these before the steel goes in. A Charlton Kings project that only redecorates or moves a non-structural partition does not, but almost anything that opens the structure does.
No — they are a separate, later step. Planning permission decides whether Cheltenham Borough Council will allow the change; structural calculations prove the change is safe to build and are submitted to building control, not to the planners. Many Charlton Kings projects that need no planning permission at all — an internal knock-through, a permitted-development loft — still need a full engineer's calculation before work can lawfully start.
A chartered or incorporated structural engineer, carrying professional indemnity insurance, who takes responsibility for the numbers. Cheltenham Borough Council's building control, or an approved inspector acting on your behalf, then checks and signs them off. Your builder cannot self-certify a steel beam, and an unsigned calculation will not be accepted — the engineer's signature and insurance are what make the package one building control will approve. This applies to your Charlton Kings address specifically.
Yes — a beam over a removed wall is the most common calculation we do. We work out the load the wall was carrying, size a steel or timber beam to span the opening within safe deflection, and detail the padstones that spread its weight into the masonry each side. The result is a beam schedule your Charlton Kings builder can order and Cheltenham Borough Council's inspector can approve, with the load traced all the way to the foundations.
Sometimes. Where the loads are clear from the drawings we can calculate directly, but Charlton Kings's older stock often hides surprises — a wall that turns out to be load-bearing, notched or altered joists, or shallow foundations near Cudnall Street and St Mary's. In those cases a short structural survey means the beam is sized on what is really there, which avoids a redesign once the builder opens the wall. Cheltenham Borough Council is the decision-maker.
We price each Charlton Kings package on the number of beams and the complexity — a single knock-through is straightforward, a whole-house loft-and-extension scheme has several elements — and send a fixed, no-obligation quote within one working day. It covers the calculations, the beam schedule and free revisions until Cheltenham Borough Council's building control approves. Call 020 7864 7245 to start.
Answer five quick questions and get a free planning score for your exact address — instantly. Then, if you want the full picture, unlock the detailed analysis: your council's live approval rates, local precedents, constraints on your street and a step-by-step route to permission.
Same fixed quotes, same fast drawings — wherever your project is.