Side-return infill drawings for St Peters terraces — the glazed extension that fills the redundant side alley and opens up the kitchen, drawn to Thanet District Council's guidance, delivered in days and revised free until your decision, with a free approval-odds check first.
Thanet District Council granted 94% of the householder planning decisions it made in its latest published year — 7 points above the 87% England-wide householder average. St Peters contains the St Peters Conservation Area conservation area, so materials, fenestration and roof form are assessed against the appraisal, which is where a policy-literate drawing pack earns its keep. Its dominant Victorian (1837–1901) and postwar (1945–1970) housing stock sets the design brief on most streets.
Class A and Class B set the thresholds — a rear dormer to 40m³ on a terrace or 50m³ on a semi or detached, and a single-storey rear extension to 3m on a terrace or 4m on a detached house — beyond which Thanet District Council needs a full application. In conservation areas such as St Peters Conservation Area those rights are removed, so we confirm your exact address before a line is drawn. A validated householder application in St Peters is determined against an 8-week statutory target.
St Peters (designated conservation area) and Broadstairs and St. Peters (civil parish within St Peters) — these are the St Peters pockets our drawings cover most. Heritage designations here include St Peters Conservation Area. Thanet District Council weighs each proposal against the adopted Thanet local plan and Thanet District Council's design guidance for householder work, where the 3,560 homes here are 23% 1973-1982, 15% pre-1900, 14% 1965-1972, which is what sets the realistic roof and rear-projection options. On roofs the borough is shallow trussed roofs typical of 1970s building and steeply pitched slate roofs, valley gutters and party parapets typical of pre-1900 building, over 1970s and early-1980s houses (23% of 3,560 homes), Victorian and earlier houses (15%) and late-1960s and early-1970s houses (14%).
Heritage designation is the single biggest variable in St Peters, and it is address-specific: St Peters (designated conservation area). Inside those boundaries permitted development is curtailed and Thanet District Council assesses materials, window detail and roof form against the area's own appraisal, so a scheme that would be waved through two streets away can need a full application here.
Beyond the designated areas, St Peters takes in Broadstairs and St. Peters. No Article 4 direction is recorded for Thanet District Council, but St Peters's 1 conservation area still limit permitted development on those streets.
On stock, St Peters is 1970s and early-1980s houses (23% of 3,560 homes), Victorian and earlier houses (15%) and late-1960s and early-1970s houses (14%) — which is why shallow trussed roofs typical of 1970s building and steeply pitched slate roofs, valley gutters and party parapets typical of pre-1900 building govern what a loft or rear projection can realistically be. Thanet District Council decided 315 householder applications in the latest published year and granted 94%, with 62% issued inside the eight-week target. We work from the council's own published record.
The full build-period split for St Peters runs pre-1900 15% (520 homes), 1900-1918 4% (130 homes), 1919-1929 3% (110 homes), 1930-1939 7% (250 homes), 1945-1954 2% (60 homes), 1955-1964 11% (400 homes), 1965-1972 14% (490 homes), 1973-1982 23% (830 homes), 1983-1992 4% (140 homes), 1993-1999 4% (140 homes) and 2000-2008 4% (150 homes). That distribution is why pre-1900 detailing dominates the drawings here, and it is measured from council-tax records rather than assumed from the street name.
Thanet District Council also decides for Beacon Road, Birchington South, Bradstowe, Central Harbour, Cliffsend and Pegwell, Cliftonville West, Kingsgate and Sir Moses Montefiore, so a decision in St Peters sits inside a wider pattern of decisions we track across the same authority — useful when an officer cites a precedent from the next area over.
Published figures for St Peters and Thanet District Council. These are the numbers that decide what is realistic on your street, so we work from them rather than from national averages.
| Measure | St Peters |
|---|---|
| Dwellings recorded | 3,560 |
| Built pre-1900 | 520 (15%) |
| Built 1900-1918 | 130 (4%) |
| Built 1919-1929 | 110 (3%) |
| Built 1930-1939 | 250 (7%) |
| Built 1945-1954 | 60 (2%) |
| Built 1955-1964 | 400 (11%) |
| Built 1965-1972 | 490 (14%) |
| Built 1973-1982 | 830 (23%) |
| Built 1983-1992 | 140 (4%) |
| Built 1993-1999 | 140 (4%) |
| Built 2000-2008 | 150 (4%) |
| Built before 1919 | 18% |
| Built 1919–1939 | 10% |
| Built 1945–2008 | 62% |
| Conservation areas in St Peters | 1 (St Peters Conservation Area) |
| Conservation areas district-wide | 27 |
| Article 4 directions recorded | 0 |
| Householder applications decided | 315 |
| Householder applications granted | 94% |
| Decided within 8 weeks | 62% |
Dwelling stock from VOA council-tax data at 31 March 2025; conservation-area and Article 4 counts from planning.data.gov.uk (MHCLG); decision figures are Thanet District Council's own, from MHCLG live table PS2 for the year to 31 March 2026.
The side return is the classic terrace fix, and St Peters has the stock for it — the borough is built largely from 1970s and early-1980s houses (23% of 3,560 homes), Victorian and earlier houses (15%) and late-1960s and early-1970s houses (14%), and the Victorian and Edwardian versions almost all have an L-shaped back addition with a wasted alley beside it. Fill that alley and the dark galley kitchen becomes a bright, square room the full width of the house. Thanet District Council judges the infill against the adopted Thanet local plan and Thanet District Council's design guidance for householder work, and because it runs along the party boundary, the neighbour relationship is read before the design.
That boundary is where the drawings earn their keep. We set the infill wall on or up to the line, keep the roof — usually a glazed lantern or a shallow pitch tying into the existing back-addition slope — below the neighbour's first-floor windows, and detail the rainwater and party-wall junction so the build is watertight and the Party Wall Act is satisfied. St Peters contains the St Peters Conservation Area conservation area, so materials, fenestration and roof form are assessed against the appraisal, so we resolve it on the section rather than leave it to the case officer.
Many of St Peters's terraces sit in conservation areas — St Peters Conservation Area among them — where a side extension is no longer permitted development. No Article 4 direction is recorded for Thanet District Council, but St Peters's 1 conservation area still limit permitted development on those streets. We confirm the designation before a line is drawn.
Some single-storey side returns in St Peters are permitted development, but the width and boundary make an application more likely than for a straight rear extension. You will normally need to apply to Thanet District Council if any of these apply:
We draw the infill wall on the boundary, the glazed roof below the neighbour's windows and the party-wall junction on the page — the details Thanet District Council's officers and your neighbour both check — and submit a validation-complete pack, whether that is a lawful development certificate or a full householder application.
Below is Thanet District Council's real householder decision record, drawn from official planning statistics and refreshed as new data lands. Thanet District Council granted 94% of its householder applications in the year to 31 March 2026, and St Peters Conservation Area shapes what is approved here. Side returns hinge on width, roof glazing and the party boundary, so a pack that resolves those details upfront is decided faster and refused less often than a DIY submission.
Source: MHCLG planning application statistics (householder decisions, England, 1 April 2025 - 31 March 2026). Compare every borough on our London approval-rate league table.
Tell us about your project and get a fixed, no-obligation quote back within one working day. If you don't need planning permission at all, we'll tell you that too — for free.
Across St Peters and Broadstairs and St. Peters, the approved side return is a single-storey infill roofed with a glazed lantern or roof light to pull daylight deep into the plan, its flank wall built on the boundary and finished to match the host brick. On the borough's 1970s and early-1980s houses (23% of 3,560 homes), this is frequently the single biggest gain in usable ground-floor space, and where it stays within the width and height limits it can proceed under permitted development or a lawful development certificate.
The 3,560 homes here are 23% 1973-1982, 15% pre-1900, 14% 1965-1972, which is what sets the realistic roof and rear-projection options. We keep the glazed roof below the neighbour's cill line, set the gutter and the party-wall flashing so water and maintenance are designed in, and — where owners want the full open-plan room — pair the infill with a rear extension as a single wraparound application. That way Thanet District Council sees one coherent scheme rather than two overlapping ones.
We draw side-return infills on every terraced street in the borough. A few of the neighbourhoods where St Peters side returns come up most often:
Side return extension drawings for St Peters's designated conservation area — width-checked, party-wall detailed and drawn to Thanet District Council's guidance.
Side return extension drawings for Broadstairs and St. Peters's civil parish within St Peters — width-checked, party-wall detailed and drawn to Thanet District Council's guidance.
Whether a side return in St Peters needs permission comes down to width, storeys and whether the street is designated. This is how the cases compare.
| Side return type | Permitted development? | What it gains | What Thanet District Council checks |
|---|---|---|---|
| Single-storey infill, within limits | Often yes, if under half the house width | Full-width kitchen-diner | Width, 4m height, roof glazing |
| Single-storey, over half width | No — full application | Wider room, more light | Boundary treatment, neighbour amenity |
| Two-storey side return | No — full application | Room above as well as below | Bulk, overlooking, terrace rhythm |
| Wraparound (side + rear) | No — full application | L-shaped open-plan ground floor | Combined footprint, garden retained |
In conservation areas such as St Peters Conservation Area, side extensions are not permitted development and always need a full application.
A fixed process built around how Thanet District Council validates and decides side-return applications — most drawings are submission-ready within seven days of survey.
Send us your St Peters postcode and terrace type. We confirm your conservation and Article 4 status, whether the infill stays within the side-extension width limit, and score your odds against live Thanet District Council decisions.
We measure the side alley, the back-addition wall, floor and eaves levels and the neighbour's window heights — the numbers the width limit, roof pitch and party-wall detailing depend on.
Chartered designers develop the infill and its glazed roof to your brief, drawn inside the permitted-development limits or to Thanet District Council's extension guidance, with the boundary and party-wall junction detailed.
We submit the certificate or application, manage validation and case-officer queries, and revise the drawings free until Thanet District Council issues its decision.
Sometimes not. A single-storey side-return infill can be permitted development if it is no wider than half the original house, no higher than 4 metres, and the property is not on designated land. In St Peters you will need a full application to Thanet District Council for anything wider or taller, for a two-storey side return, and for any side extension in a conservation area such as St Peters Conservation Area, where those rights are removed.
It is an infill that fills the narrow open alley running alongside the rear back-addition of a Victorian or Edwardian terrace — the strip of ground that is usually too small to use. Building over it squares off the ground floor, so a cramped galley kitchen becomes a full-width room. St Peters's period terraces are ideally suited to it, which is why the side return is one of the borough's most common extensions. Thanet District Council is the decision-maker.
Almost always. A side return is built on or up to the boundary with your neighbour, so the Party Wall etc. Act applies and you must serve notice before work starts — this is entirely separate from Thanet District Council's planning decision. We detail the party-wall junction on the drawings and flag the notice early so a surveyor can be appointed without delaying the build. This applies to your St Peters address specifically.
Yes, and it is common — the combined L-shape is a wraparound extension. Once the side infill joins a rear projection beyond the permitted-development depth, the whole thing needs a full householder application to Thanet District Council rather than qualifying as permitted development. We draw it as one coherent scheme so the council assesses a single footprint, which reads more clearly than two overlapping proposals. This applies to your St Peters address specifically.
A householder planning application in St Peters runs to a statutory eight-week target, and a lawful development certificate to eight weeks as well, though an incomplete pack can stall at validation. Because a side return involves the boundary and roof glazing, a complete, well-detailed submission matters — we prepare it validation-complete and manage officer queries to keep the decision on track. Thanet District Council is the decision-maker.
We price each St Peters side return individually, because alley width and roof form vary house to house, and send a fixed, no-obligation quote within one working day. It covers the full drawing pack with free revisions until Thanet District Council approves, and we confirm at the outset whether your infill is permitted development or needs an application. Call 020 7864 7245 to start.
Answer five quick questions and get a free planning score for your exact address — instantly. Then, if you want the full picture, unlock the detailed analysis: your council's live approval rates, local precedents, constraints on your street and a step-by-step route to permission.
Same fixed quotes, same fast drawings — wherever your project is.