Rear dormer drawings for Plumstead roofs — the box across the back slope that turns a low attic into a full-height room, drawn to Broadland District Council's guidance and the volume limits, delivered in days and revised free until your decision, with a free approval-odds check first.
Broadland District Council granted 97% of the householder planning decisions it made in its latest published year — 10 points above the 87% England-wide householder average. Plumstead contains the Thorpe End Garden Village conservation area (Thorpe End Garden Village designated 2010), so materials, fenestration and roof form are assessed against the appraisal, which is where a policy-literate drawing pack earns its keep. Its dominant postwar (1945–1970) housing stock sets the design brief on most streets.
Before permission is required, Class B allows 40m³ of added loft volume on a terrace and 50m³ on a semi or detached house, and Class A allows a 3m single-storey rear extension on a terrace or 4m on a detached house. Plumstead carries at least one Article 4 direction, and conservation areas including Thorpe End Garden Village remove those rights outright, so we confirm your exact address before a line is drawn. A validated householder application in Plumstead is determined against an 8-week statutory target.
Thorpe End Garden Village (conservation area designated in 2010) and Great and Little Plumstead (civil parish within Plumstead) — these are the Plumstead pockets our drawings cover most. Heritage designations here include Thorpe End Garden Village. Broadland District Council weighs each proposal against Broadland District Council's development plan and the design policies it applies to householder applications, where the 1,500 homes here are 16% 2000-2008, 14% 1983-1992, 10% 1965-1972, which is what sets the realistic roof and rear-projection options. On roofs the borough is trussed-rafter roofs typical of 2000s building and trussed-rafter roofs typical of 1980s building, over 2000s houses and apartments (16% of 1,500 homes), 1980s estate houses (14%) and late-1960s and early-1970s houses (10%).
What is permitted in Plumstead turns on designation first, so that is where we start: Thorpe End Garden Village (conservation area designated in 2010). Inside those boundaries permitted development is curtailed and Broadland District Council assesses materials, window detail and roof form against the area's own appraisal, so a scheme that would be waved through two streets away can need a full application here.
Beyond the designated areas, Plumstead takes in Great and Little Plumstead. Broadland District Council has 28 recorded Article 4 directions — check the address before assuming PD applies in Plumstead.
On stock, Plumstead is 2000s houses and apartments (16% of 1,500 homes), 1980s estate houses (14%) and late-1960s and early-1970s houses (10%) — which is why trussed-rafter roofs typical of 2000s building and trussed-rafter roofs typical of 1980s building govern what a loft or rear projection can realistically be. Broadland District Council decided 470 householder applications in the latest published year and granted 97%, with 68% issued inside the eight-week target. We draw to that record rather than to a national average.
The full build-period split for Plumstead runs pre-1900 5% (80 homes), 1900-1918 1% (10 homes), 1919-1929 1% (20 homes), 1930-1939 6% (90 homes), 1945-1954 3% (40 homes), 1955-1964 9% (130 homes), 1965-1972 10% (150 homes), 1973-1982 9% (130 homes), 1983-1992 14% (210 homes), 1993-1999 9% (130 homes) and 2000-2008 16% (240 homes). That distribution is why pre-1900 detailing dominates the drawings here, and it is measured from council-tax records rather than assumed from the street name.
Broadland District Council also decides for Aylsham, Eynesford, Hellesdon North West, Marshes, Wroxham and Coltishall, so a decision in Plumstead sits inside a wider pattern of decisions we track across the same authority — useful when an officer cites a precedent from the next area over.
The Article 4 directions recorded for this council include Area centred on the Market Place, Broads Authoriity Holly Lodge, Broads Authority and Broads Authority Conservation Area. Each removes a specific permitted-development right inside its own boundary, which is why the check is done on the address rather than on the town.
Published figures for Plumstead and Broadland District Council. These are the numbers that decide what is realistic on your street, so we work from them rather than from national averages.
| Measure | Plumstead |
|---|---|
| Dwellings recorded | 1,500 |
| Built pre-1900 | 80 (5%) |
| Built 1900-1918 | 10 (1%) |
| Built 1919-1929 | 20 (1%) |
| Built 1930-1939 | 90 (6%) |
| Built 1945-1954 | 40 (3%) |
| Built 1955-1964 | 130 (9%) |
| Built 1965-1972 | 150 (10%) |
| Built 1973-1982 | 130 (9%) |
| Built 1983-1992 | 210 (14%) |
| Built 1993-1999 | 130 (9%) |
| Built 2000-2008 | 240 (16%) |
| Built before 1919 | 6% |
| Built 1919–1939 | 7% |
| Built 1945–2008 | 69% |
| Conservation areas in Plumstead | 1 (Thorpe End Garden Village) |
| Conservation areas district-wide | 31 |
| Article 4 directions recorded | 28 |
| Householder applications decided | 470 |
| Householder applications granted | 97% |
| Decided within 8 weeks | 68% |
Dwelling stock from VOA council-tax data at 31 March 2025; conservation-area and Article 4 counts from planning.data.gov.uk (MHCLG); decision figures are Broadland District Council's own, from MHCLG live table PS2 for the year to 31 March 2026.
The box dormer is the workhorse loft, and most of Plumstead is built for it — the borough runs to 2000s houses and apartments (16% of 1,500 homes), 1980s estate houses (14%) and late-1960s and early-1970s houses (10%) under trussed-rafter roofs typical of 2000s building and trussed-rafter roofs typical of 1980s building, and a flat-roofed box across the rear slope is the cheapest cubic metre of full-height space those roofs give up. Broadland District Council tests the dormer against Broadland District Council's development plan and the design policies it applies to householder applications, and because permitted development turns on a number, the volume you propose against the volume you have left is the first thing an officer or a certificate checks.
That is why the arithmetic goes on the drawings. We calculate the box against the 40- or 50-cubic-metre allowance, count any earlier roof enlargement into the total, hold the flat roof below the ridge and set the face back off the eaves so the dormer reads as subordinate. Plumstead contains the Thorpe End Garden Village conservation area (Thorpe End Garden Village designated 2010), so materials, fenestration and roof form are assessed against the appraisal, so the cheeks, the window line and the material are drawn to answer it rather than invite a query.
Where Plumstead's streets are protected — Thorpe End Garden Village among them — the Class B dormer right is switched off and even a modest rear box needs consent. Broadland District Council has 28 recorded Article 4 directions — check the address before assuming PD applies in Plumstead. We confirm the designation before the box is sized.
Many rear dormers in Plumstead are permitted development, but the volume and position decide it. You will normally need a full application to Broadland District Council if any of these apply:
We draw the box within its volume allowance, the flat roof below the ridge and the face set back off the eaves — the three things a dormer stands or falls on — and submit a validation-complete pack, whether that is a lawful development certificate or a full householder application.
Below is Broadland District Council's real householder decision record, drawn from official planning statistics and refreshed as new data lands. Broadland District Council granted 97% of its householder applications in the year to 31 March 2026, and Thorpe End Garden Village shapes what is approved here. A dormer is decided on volume and set-back, so a pack that shows the calculation and the eaves detail is cleared faster and refused less often than a DIY submission.
Source: MHCLG planning application statistics (householder decisions, England, 1 April 2025 - 31 March 2026). Compare every borough on our London approval-rate league table.
Tell us about your project and get a fixed, no-obligation quote back within one working day. If you don't need planning permission at all, we'll tell you that too — for free.
Across Thorpe End Garden Village and Great and Little Plumstead, the dormer that goes through is the subordinate rear box: flat roof kept low, cheeks clad to recede, side windows obscure-glazed against overlooking, and the whole thing set back so the original eaves line still reads from the garden. On trussed-rafter roofs typical of 2000s building, this returns a full-height double and en-suite from what was standing-room-only, usually inside the permitted-development volume.
The 1,500 homes here are 16% 2000-2008, 14% 1983-1992, 10% 1965-1972, which is what sets the realistic roof and rear-projection options. We keep the box off the ridge, match the cheek material to the roof, and where the volume is already spent — or the street is designated — draw the dormer as a householder application composed to Broadland District Council's roof-alteration guidance rather than push a certificate that would be refused.
We draw rear dormers on the terraced and semi-detached streets across the borough. A few of the neighbourhoods where Plumstead dormers come up most often:
Dormer loft drawings for Thorpe End Garden Village's conservation area designated in 2010 — volume-checked, set-back-detailed and drawn to Broadland District Council's guidance.
Dormer loft drawings for Great and Little Plumstead's civil parish within Plumstead — volume-checked, set-back-detailed and drawn to Broadland District Council's guidance.
Whether a dormer in Plumstead needs permission comes down to where it sits and how big the box is. This is how the cases compare.
| Dormer type | Permitted development? | What it gains | What Broadland District Council checks |
|---|---|---|---|
| Rear box, within volume | Usually yes | Full-height room across the back | Volume total, 20cm eaves set-back |
| Rear box, over volume limit | No — full application | A larger room | How far over the allowance, bulk |
| Front or side dormer | No — full application | Light to the front rooms | Visibility from the street, character |
| Dormer in a conservation area | No — full application | Same space, extra scrutiny | Roof form and street appearance |
In conservation areas such as Thorpe End Garden Village, Class B dormer rights are removed and every dormer needs a full application.
A fixed process built around how Broadland District Council validates and decides dormer applications — most drawings are submission-ready within seven days of survey.
Send us your Plumstead postcode and roof type. We confirm your conservation and Article 4 status, work out how much permitted-development volume you have left, and score your odds against live Broadland District Council decisions.
We measure ridge and eaves heights, roof pitch and the existing loft floor — the numbers the volume calculation, the set-back and the head heights depend on.
Chartered designers develop the box to your brief, drawn inside the Class B volume limits or, where those are exhausted or removed, to Broadland District Council's roof-alteration guidance.
We submit the certificate or application, manage validation and case-officer queries, and revise the drawings free until Broadland District Council issues its decision.
Often not. A rear box dormer within 40 cubic metres on a terrace, or 50 on a semi or detached house, set back at least 20 centimetres from the eaves and kept below the ridge, is usually permitted development. In Plumstead you will need a full application to Broadland District Council for a front or side dormer, a box that exceeds the volume, and any dormer in a conservation area such as Thorpe End Garden Village, where those rights are removed.
The permitted-development limit is a volume, not a footprint: 40 cubic metres of added roof space on a terraced house and 50 on a semi-detached or detached one, and any earlier loft enlargement counts against that total. In Plumstead the box must also sit below the ridge and back from the eaves. We measure your roof and calculate the exact volume you have left before drawing. Broadland District Council is the decision-maker.
Not under permitted development. A dormer on the front roof slope, or one facing a highway, always needs a full application to Broadland District Council, because it changes how the house reads from the street. Rear box dormers are far more likely to be approved — or to be permitted development outright — which is why almost every Plumstead dormer we draw sits on the back slope.
Often, on a terrace or semi. If the dormer or the loft steelwork meets the party wall with your neighbour, the Party Wall etc. Act applies and notice must be served before work starts — separately from Broadland District Council's planning decision. We flag the party-wall junction on the drawings so a surveyor can be appointed early and the build is not held up. This applies to your Plumstead address specifically.
If your dormer is permitted development, a lawful development certificate from Broadland District Council is council-stamped proof of it — worth holding, because a buyer's solicitor will ask for it when you sell. We prepare and submit the certificate with the same measured drawing pack that shows the box within its volume allowance. This applies to your Plumstead address specifically.
We price each Plumstead dormer individually, because the roof pitch and the volume left vary house to house, and send a fixed, no-obligation quote within one working day. It covers the full drawing pack with free revisions until Broadland District Council approves, and we confirm at the outset whether your box is permitted development or needs an application. Call 020 7864 7245 to start.
Answer five quick questions and get a free planning score for your exact address — instantly. Then, if you want the full picture, unlock the detailed analysis: your council's live approval rates, local precedents, constraints on your street and a step-by-step route to permission.
Same fixed quotes, same fast drawings — wherever your project is.