Rear dormer drawings for Boultham roofs — the box across the back slope that turns a low attic into a full-height room, drawn to City of Lincoln Council's guidance and the volume limits, delivered in days and revised free until your decision, with a free approval-odds check first.
City of Lincoln Council granted 99% of the householder planning decisions it made in its latest published year — 12 points above the 87% England-wide householder average. Boultham contains Gowt's Bridge, St Peter-at-Gowts, Swanpool conservation areas (Swanpool designated 1986), so materials, fenestration and roof form are assessed against the appraisal, which is where a policy-literate drawing pack earns its keep. Its dominant Edwardian (1901–1910) and interwar (1918–1939) housing stock sets the design brief on most streets.
Under Class B, a rear dormer stays permitted development up to 40m³ of added roof volume on a terrace or 50m³ on a semi-detached or detached house, while Class A allows a single-storey rear extension of 3m beyond the original rear wall on a terrace and 4m on a detached house before a full application is needed. In conservation areas such as Gowt's Bridge, St Peter-at-Gowts and Swanpool those rights are removed, so we confirm your exact address before a line is drawn. A validated householder application in Boultham is determined against an 8-week statutory target.
Gowt's Bridge (designated conservation area), St Peter-at-Gowts (designated conservation area) and Swanpool (conservation area designated in 1986) — these are the Boultham pockets our drawings cover most. Heritage designations here include Gowt's Bridge, St Peter-at-Gowts and Swanpool. City of Lincoln Council weighs each proposal against City of Lincoln Council's development plan and the design policies it applies to householder applications, where the 5,380 homes here are 17% 2000-2008, 10% 1930-1939, 9% 1900-1918, which is what sets the realistic roof and rear-projection options. On roofs the borough is trussed-rafter roofs typical of 2000s building and hipped roofs with shallow pitches typical of 1930s building, over 2000s houses and apartments (17% of 5,380 homes), 1930s semi-detached and detached houses (10%) and Edwardian houses (9%).
Boultham's designated heritage is specific, and it is the first thing we check against your address: Gowt's Bridge (designated conservation area), St Peter-at-Gowts (designated conservation area) and Swanpool (conservation area designated in 1986). Inside those boundaries permitted development is curtailed and City of Lincoln Council assesses materials, window detail and roof form against the area's own appraisal, so a scheme that would be waved through two streets away can need a full application here.
No Article 4 direction is recorded for City of Lincoln Council, but Boultham's 3 conservation areas still limit permitted development on those streets.
On stock, Boultham is 2000s houses and apartments (17% of 5,380 homes), 1930s semi-detached and detached houses (10%) and Edwardian houses (9%) — which is why trussed-rafter roofs typical of 2000s building and hipped roofs with shallow pitches typical of 1930s building govern what a loft or rear projection can realistically be. City of Lincoln Council decided 115 householder applications in the latest published year and granted 99%, with 79% issued inside the eight-week target. Those are the numbers our drawings are prepared against.
The full build-period split for Boultham runs pre-1900 7% (380 homes), 1900-1918 9% (460 homes), 1919-1929 4% (200 homes), 1930-1939 10% (540 homes), 1945-1954 5% (270 homes), 1955-1964 5% (250 homes), 1965-1972 0% (20 homes), 1973-1982 3% (180 homes), 1983-1992 3% (170 homes), 1993-1999 4% (210 homes) and 2000-2008 17% (890 homes). That distribution is why pre-1900 detailing dominates the drawings here, and it is measured from council-tax records rather than assumed from the street name.
City of Lincoln Council also decides for Abbey, Carholme and Park, so a decision in Boultham sits inside a wider pattern of decisions we track across the same authority — useful when an officer cites a precedent from the next area over.
Published figures for Boultham and City of Lincoln Council. These are the numbers that decide what is realistic on your street, so we work from them rather than from national averages.
| Measure | Boultham |
|---|---|
| Dwellings recorded | 5,380 |
| Built pre-1900 | 380 (7%) |
| Built 1900-1918 | 460 (9%) |
| Built 1919-1929 | 200 (4%) |
| Built 1930-1939 | 540 (10%) |
| Built 1945-1954 | 270 (5%) |
| Built 1955-1964 | 250 (5%) |
| Built 1965-1972 | 20 (0%) |
| Built 1973-1982 | 180 (3%) |
| Built 1983-1992 | 170 (3%) |
| Built 1993-1999 | 210 (4%) |
| Built 2000-2008 | 890 (17%) |
| Built before 1919 | 16% |
| Built 1919–1939 | 14% |
| Built 1945–2008 | 37% |
| Conservation areas in Boultham | 3 (Gowt's Bridge, St Peter-at-Gowts…) |
| Conservation areas district-wide | 11 |
| Article 4 directions recorded | 0 |
| Householder applications decided | 115 |
| Householder applications granted | 99% |
| Decided within 8 weeks | 79% |
Dwelling stock from VOA council-tax data at 31 March 2025; conservation-area and Article 4 counts from planning.data.gov.uk (MHCLG); decision figures are City of Lincoln Council's own, from MHCLG live table PS2 for the year to 31 March 2026.
The box dormer is the workhorse loft, and most of Boultham is built for it — the borough runs to 2000s houses and apartments (17% of 5,380 homes), 1930s semi-detached and detached houses (10%) and Edwardian houses (9%) under trussed-rafter roofs typical of 2000s building and hipped roofs with shallow pitches typical of 1930s building, and a flat-roofed box across the rear slope is the cheapest cubic metre of full-height space those roofs give up. City of Lincoln Council tests the dormer against City of Lincoln Council's development plan and the design policies it applies to householder applications, and because permitted development turns on a number, the volume you propose against the volume you have left is the first thing an officer or a certificate checks.
That is why the arithmetic goes on the drawings. We calculate the box against the 40- or 50-cubic-metre allowance, count any earlier roof enlargement into the total, hold the flat roof below the ridge and set the face back off the eaves so the dormer reads as subordinate. Boultham contains Gowt's Bridge, St Peter-at-Gowts, Swanpool conservation areas (Swanpool designated 1986), so materials, fenestration and roof form are assessed against the appraisal, so the cheeks, the window line and the material are drawn to answer it rather than invite a query.
Where Boultham's streets are protected — Gowt's Bridge, St Peter-at-Gowts and Swanpool among them — the Class B dormer right is switched off and even a modest rear box needs consent. No Article 4 direction is recorded for City of Lincoln Council, but Boultham's 3 conservation areas still limit permitted development on those streets. We confirm the designation before the box is sized.
Many rear dormers in Boultham are permitted development, but the volume and position decide it. You will normally need a full application to City of Lincoln Council if any of these apply:
We draw the box within its volume allowance, the flat roof below the ridge and the face set back off the eaves — the three things a dormer stands or falls on — and submit a validation-complete pack, whether that is a lawful development certificate or a full householder application.
Below is City of Lincoln Council's real householder decision record, drawn from official planning statistics and refreshed as new data lands. City of Lincoln Council granted 99% of its householder applications in the year to 31 March 2026, and Gowt's Bridge shapes what is approved here. A dormer is decided on volume and set-back, so a pack that shows the calculation and the eaves detail is cleared faster and refused less often than a DIY submission.
Source: MHCLG planning application statistics (householder decisions, England, 1 April 2025 - 31 March 2026). Compare every borough on our London approval-rate league table.
Tell us about your project and get a fixed, no-obligation quote back within one working day. If you don't need planning permission at all, we'll tell you that too — for free.
Across Gowt's Bridge, St Peter-at-Gowts and Swanpool, the dormer that goes through is the subordinate rear box: flat roof kept low, cheeks clad to recede, side windows obscure-glazed against overlooking, and the whole thing set back so the original eaves line still reads from the garden. On trussed-rafter roofs typical of 2000s building, this returns a full-height double and en-suite from what was standing-room-only, usually inside the permitted-development volume.
The 5,380 homes here are 17% 2000-2008, 10% 1930-1939, 9% 1900-1918, which is what sets the realistic roof and rear-projection options. We keep the box off the ridge, match the cheek material to the roof, and where the volume is already spent — or the street is designated — draw the dormer as a householder application composed to City of Lincoln Council's roof-alteration guidance rather than push a certificate that would be refused.
We draw rear dormers on the terraced and semi-detached streets across the borough. A few of the neighbourhoods where Boultham dormers come up most often:
Dormer loft drawings for Gowt's Bridge's designated conservation area — volume-checked, set-back-detailed and drawn to City of Lincoln Council's guidance.
Dormer loft drawings for St Peter-at-Gowts's designated conservation area — volume-checked, set-back-detailed and drawn to City of Lincoln Council's guidance.
Dormer loft drawings for Swanpool's conservation area designated in 1986 — volume-checked, set-back-detailed and drawn to City of Lincoln Council's guidance.
Whether a dormer in Boultham needs permission comes down to where it sits and how big the box is. This is how the cases compare.
| Dormer type | Permitted development? | What it gains | What City of Lincoln Council checks |
|---|---|---|---|
| Rear box, within volume | Usually yes | Full-height room across the back | Volume total, 20cm eaves set-back |
| Rear box, over volume limit | No — full application | A larger room | How far over the allowance, bulk |
| Front or side dormer | No — full application | Light to the front rooms | Visibility from the street, character |
| Dormer in a conservation area | No — full application | Same space, extra scrutiny | Roof form and street appearance |
In conservation areas such as Gowt's Bridge and St Peter-at-Gowts, Class B dormer rights are removed and every dormer needs a full application.
A fixed process built around how City of Lincoln Council validates and decides dormer applications — most drawings are submission-ready within seven days of survey.
Send us your Boultham postcode and roof type. We confirm your conservation and Article 4 status, work out how much permitted-development volume you have left, and score your odds against live City of Lincoln Council decisions.
We measure ridge and eaves heights, roof pitch and the existing loft floor — the numbers the volume calculation, the set-back and the head heights depend on.
Chartered designers develop the box to your brief, drawn inside the Class B volume limits or, where those are exhausted or removed, to City of Lincoln Council's roof-alteration guidance.
We submit the certificate or application, manage validation and case-officer queries, and revise the drawings free until City of Lincoln Council issues its decision.
Often not. A rear box dormer within 40 cubic metres on a terrace, or 50 on a semi or detached house, set back at least 20 centimetres from the eaves and kept below the ridge, is usually permitted development. In Boultham you will need a full application to City of Lincoln Council for a front or side dormer, a box that exceeds the volume, and any dormer in a conservation area such as Gowt's Bridge and St Peter-at-Gowts, where those rights are removed.
The permitted-development limit is a volume, not a footprint: 40 cubic metres of added roof space on a terraced house and 50 on a semi-detached or detached one, and any earlier loft enlargement counts against that total. In Boultham the box must also sit below the ridge and back from the eaves. We measure your roof and calculate the exact volume you have left before drawing. City of Lincoln Council is the decision-maker.
Not under permitted development. A dormer on the front roof slope, or one facing a highway, always needs a full application to City of Lincoln Council, because it changes how the house reads from the street. Rear box dormers are far more likely to be approved — or to be permitted development outright — which is why almost every Boultham dormer we draw sits on the back slope.
Often, on a terrace or semi. If the dormer or the loft steelwork meets the party wall with your neighbour, the Party Wall etc. Act applies and notice must be served before work starts — separately from City of Lincoln Council's planning decision. We flag the party-wall junction on the drawings so a surveyor can be appointed early and the build is not held up. This applies to your Boultham address specifically.
If your dormer is permitted development, a lawful development certificate from City of Lincoln Council is council-stamped proof of it — worth holding, because a buyer's solicitor will ask for it when you sell. We prepare and submit the certificate with the same measured drawing pack that shows the box within its volume allowance. This applies to your Boultham address specifically.
We price each Boultham dormer individually, because the roof pitch and the volume left vary house to house, and send a fixed, no-obligation quote within one working day. It covers the full drawing pack with free revisions until City of Lincoln Council approves, and we confirm at the outset whether your box is permitted development or needs an application. Call 020 7864 7245 to start.
Answer five quick questions and get a free planning score for your exact address — instantly. Then, if you want the full picture, unlock the detailed analysis: your council's live approval rates, local precedents, constraints on your street and a step-by-step route to permission.
Same fixed quotes, same fast drawings — wherever your project is.